Mostrando ítems 1-3 de 3

A time to exhaustion model during prolonged running based on wearable accelerometers

Provot, Thomas; Munera, Marcela; Chiementin, Xavier; Bolaers, Fabrice (Taylor and Francis Ltd.Reino Unido, 2019)

Defining relationships between running mechanisms and fatigue can be a major asset for optimising training. This article proposes a biomechanical model of time to exhaustion according to indicators derived from accelerometry ...
Contribution of Bamboo for Vibratory Comfort in Biomechanics of Cycling

Chiementin, Xavier; Crequy, Samuel; Feron, Robin; Munera, Marcela; Abdi, Ellie; Provot, Thomas; Taiar, Redha (Bentham Science Publishers B.V.Suiza, 2017)

Vibrations in cycling produced by road irregularities could cause health problems and affect the cyclist’s comfort and performance. Therefore researchers and manufacturers focus their efforts to reduce the vibrations.
Intra and Inter Test Repeatability of Accelerometric Indicators Measured While Running

Provot, Thomas; Munera, Marcela; Bolaers, Fabrice; Vitry, Gregoire; Chiementin, Xavier (Elsevier BVReino Unido, 2016)

Recently the use of Inertial Measurement Units (IMU's) has been extended to several applications in human activity. In running, several studies show the possibility of using IMU's to measure different indicators of speed ...

Envíos recientes

A time to exhaustion model during prolonged running based on wearable accelerometers
...
Provot, Thomas | 2019

Defining relationships between running mechanisms and fatigue can be a major asset for optimising training. This article proposes a biomechanical model of time to exhaustion according to indicators derived from accelerometry data collected from the body. Ten volunteers were recruited for this study. The participants were equipped with 3 accelerometers: on the right foot, at the tibia and at the L4-L5 lumbar spine. A running test was performed on a treadmill at 13.5 km/h until exhaustion. Thirty-one variables were deployed during the test. Multiple linear regressions were calculated to explain the time to exhaustion from the indicators calculated on the lumbar, tibia and foot individually and simultaneously. Time to exhaustion was predicted for simultaneous measurement points with r2=0.792 and 21 indicators; for the lumbar with r2=0.568 and 11 indicators; for the tibia with r2=558 and 11 indicators; and for the foot with r2=0.626 and 12 indicators. This study allows the accurate modelling of the time to exhaustion during a running-based test using indicators from accelerometer measurements. The individual models highlight that the location of the measurement point is important and that each location provides different information. Future studies should focus on homogeneous populations to improve predictions and errors.

LEER
Contribution of Bamboo for Vibratory Comfort in Biomechanics of Cycling
...
Chiementin, Xavier | 2017

Vibrations in cycling produced by road irregularities could cause health problems and affect the cyclist’s comfort and performance. Therefore researchers and manufacturers focus their efforts to reduce the vibrations.

LEER
Intra and Inter Test Repeatability of Accelerometric Indicators Measured While Running
...
Provot, Thomas | 2016

Recently the use of Inertial Measurement Units (IMU's) has been extended to several applications in human activity. In running, several studies show the possibility of using IMU's to measure different indicators of speed and foot strike. However, few studies describe the repeatability of those indicators. In this context, the aim of this study is to analyse the intra and inter test repeatability of several temporal and spectral indicators using an IMU under constant running conditions. Accelerations were measured using three IMU's mounted on the trunk near the lumbar, the right tibia and the dorsal surface of the right shoe above the metatarsals. The subject follows two different protocols to realize the intra test and the inter test repeatability of eight different parameters: root mean square (RMS) values of acceleration, kurtosis, total energy, median frequency, mechanical stiffness, mean stride duration, contact and flying duration. For all parameters the mean, standard deviation and coefficient of variation were computed for each set of test. The coefficient of variation was lower than 5% for both test for all parameters except kurtosis and the median frequency. Parameters with acceptable value at constant conditions of surface and speed can be used as an indicator to compare several conditions, such as the influence of speed, surface or anthropometry of the subjects.

LEER

‹›

Repositorio Digital

Listar AA. Gibiome por autor "ad6bfbf95a34697f0011b08cab1ec1cd"

A time to exhaustion model during prolonged running based on wearable accelerometers

Contribution of Bamboo for Vibratory Comfort in Biomechanics of Cycling

Intra and Inter Test Repeatability of Accelerometric Indicators Measured While Running

Envíos recientes

A time to exhaustion model during prolonged running based on wearable accelerometers

Contribution of Bamboo for Vibratory Comfort in Biomechanics of Cycling

Intra and Inter Test Repeatability of Accelerometric Indicators Measured While Running

Listar AA. Gibiome por autor "ad6bfbf95a34697f0011b08cab1ec1cd"

A time to exhaustion model during prolonged running based on wearable accelerometers ﻿

Contribution of Bamboo for Vibratory Comfort in Biomechanics of Cycling ﻿

Intra and Inter Test Repeatability of Accelerometric Indicators Measured While Running ﻿

Envíos recientes

A time to exhaustion model during prolonged running based on wearable accelerometers

Contribution of Bamboo for Vibratory Comfort in Biomechanics of Cycling

Intra and Inter Test Repeatability of Accelerometric Indicators Measured While Running

A time to exhaustion model during prolonged running based on wearable accelerometers

Contribution of Bamboo for Vibratory Comfort in Biomechanics of Cycling

Intra and Inter Test Repeatability of Accelerometric Indicators Measured While Running