Mostrar el registro sencillo del ítem

dc.contributor.authorRodríguez-Torres, Sergio David
dc.contributor.authorTorres Castellanos, Nancy
dc.date.accessioned2023-06-09T20:41:41Z
dc.date.available2023-06-09T20:41:41Z
dc.date.issued2019
dc.identifier.issn0120-5609spa
dc.identifier.urihttps://repositorio.escuelaing.edu.co/handle/001/2406
dc.description.abstractThe objective of the present research was the evaluation of some fresh and hardened-state properties of concretes, in which coarse aggregates were partially replaced by lightweight ones previously saturated, in percentages of 15 % and 25 %. The lightweight aggregates were calcined clays and crushed clay bricks. In parallel, the effect of an internal curing agent composed of superabsorbent polymers (SAP) was evaluated. The properties evaluated in the fresh and hardened-state of concretes with a/c of 0,30 were: slum, air content, density, compression resistance, modulus of elasticity, initial superficial absorption and chlorine resistance. Results showed the efficiency of crushed clay bricks as internal curing, as well as the need for deeper research on the use of the evaluated lightweight aggregate as internal curing aggregate in concrete. Results indicate that the crushed clay bricks and the internal curing agent fulfill the behavior expected, in terms of strength and durability. However, the evaluated lightweight aggregate produces a reduction in the resistance and durability of the concrete. The observed behavior in strength and durability is especially variable for the age of 180 days, compared with conventional concretes.eng
dc.description.abstractLa presente investigación tuvo como objetivo la evaluación de algunas propiedades en estado fresco y endurecido de concretos, en los cuales se realizaron reemplazos parciales de agregado grueso por agregados ligeros previamente saturados, en porcentajes de 15 % y 25 %. Los agregados ligeros fueron arcillas calcinadas y ladrillos de arcilla triturados. Paralelamente, se evaluó el efecto de un agente de curado interno compuesto por polímeros super absorbentes (SAP). Las propiedades evaluadas en estado fresco y endurecido de los concretos con una relación a/c de 0,30 fueron: asentamiento, contenido de aire, densidad, resistencia a compresión, modulo de elasticidad, tasa de absorción superficial inicial y resistencia a cloruros. Los resultados mostraron la eficiencia de los ladrillos de arcilla triturados y del agente curador interno, así como también la necesidad de realizar investigación mas profunda en la utilización del agregado ligero evaluado como agregado de curado interno en el concreto. La investigación prueba que La mampostería de arcilla triturada cumple el comportamiento esperado en un agente de curado interno desde el punto de vista de durabilidad y resistencia, mientras que el agregado ligero evaluado produjo una reducción en la resistencia y la durabilidad del concreto. El comportamiento observado en cuestión de resistencia y durabilidad es especialmente cambiante para la edad de 180 días, en comparación con los concretos convencionales.spa
dc.format.extent9 páginasspa
dc.format.mimetypeapplication/pdfspa
dc.language.isoengspa
dc.publisherUniversidad Nacional de Colombiaspa
dc.rights.urihttps://creativecommons.org/licenses/by-nc-nd/4.0/spa
dc.sourcehttps://revistas.unal.edu.co/index.php/ingeinv/article/view/76505spa
dc.titleEvaluation of internal curing effects on concreteeng
dc.title.alternativeEvaluación de los efectos del curado interno del concretospa
dc.typeArtículo de revistaspa
dc.type.versioninfo:eu-repo/semantics/publishedVersionspa
oaire.accessrightshttp://purl.org/coar/access_right/c_abf2spa
oaire.versionhttp://purl.org/coar/version/c_970fb48d4fbd8a85spa
dc.contributor.researchgroupGrupo de Investigación Estructuras y Materiales - Gimecispa
dc.identifier.doihttps://doi.org/10.15446/ing.investig.v39n2.76505
dc.identifier.eissn2248-8723spa
dc.identifier.urlhttps://revistas.unal.edu.co/index.php/ingeinv/article/view/76505
dc.publisher.placeColombiaspa
dc.relation.citationendpage45spa
dc.relation.citationissue2spa
dc.relation.citationstartpage37spa
dc.relation.citationvolume39spa
dc.relation.indexedN/Aspa
dc.relation.ispartofjournalIngeniería e Investigaciónspa
dc.relation.referencesACI Committee 211 (1991). Standard Practice for Selecting Proportions for Normal, Heavyweight, and Mass Concrete (ACI 211.1-91). Farmington Hills, MI: American Concrete Institute.spa
dc.relation.referencesACI Committee 308 (2008). Guide to Curing Concrete (ACI 308 R-01). Farmington Hills, MI: American Concrete Institute.spa
dc.relation.referencesACI Committee 308-213 (2013). Report on Internally Cured Concrete Using Prewetted Absorptive Lightweight Aggregate (ACI 308-213 R-13). Farmington Hills, MI: American Concrete Institute.spa
dc.relation.referencesAIS (2010). Reglamento colombiano de construccion sismo ´ resistente (NSR-10). Bogota: Asociaci ´ on Colombiana de ´ Ingenier´ıa S´ısmicaspa
dc.relation.referencesASTM C157/C157M-17 (2017). Standard Test Method for Length Change of Hardened Hydraulic-Cement Mortar and Concrete. West Conshohocken, PA: ASTM International. DOI: 10.1520/C0157_C0157M-17spa
dc.relation.referencesASTM C1585-13 (2013). Standard Test Method for Measurement of Rate of Absorption of Water by Hydraulic-Cement Concretes. West Conshohocken, PA: ASTM International. DOI: 10.1520/C1585-13spa
dc.relation.referencesASTM C1202 (2012). Standard Test Method for Electrical Indication of Concrete’s Ability to Resist Chloride Ion Penetration. West Conshohocken, PA: ASTM International. DOI: 10.1520/C1202-19spa
dc.relation.referencesASTM C469/C469M (2014). Standard Test Method for Static Modulus of Elasticity and Poisson’s Ratio of Concrete in Compression. West Conshohocken, PA: ASTM International. DOI: 10.1520/C0469spa
dc.relation.referencesBentz, D. P., and Weiss, W. J. (2011). Internal Curing: A 2010 State-of-the-Art Review (NIST Interagency/Internal Report (NISTIR) – 7765). DOI: 10.6028/ NIST.IR.7765spa
dc.relation.referencesCastro, J., Keiser, L., Golias, M., and Weiss, J. (2011). Absorption and desorption properties of fine lightweight aggregate for application to internally cured concrete mixtures. Cement and Concrete Composites, 33(10), 1001-1008. DOI: 10.1016/j.cemconcomp.2011.07.006spa
dc.relation.referencesCastro, J., Keiser, L., Golias, M., and Weiss, J. (2011). Absorption and desorption properties of fine lightweight aggregate for application to internally cured concrete mixtures. Cement and Concrete Composites, 33(10), 1001-1008. DOI: 10.1016/j.cemconcomp.2011.07.006spa
dc.relation.referencesDayalan, J., and Buellah, M. (2014). Internal Curing of Concrete Using Prewetted Light Weight Aggregates. International Journal of Innovative Research in Science, Engineering and Technology, 3(3), 10554-10560. Retrieved from: http: //www.ijirset.com/upload/2014/march/95_Internal.pdfspa
dc.relation.referencesICONTEC. (1994). NTC 4022 – Masa unitaria de concreto liviano estructural. Bogota: ICONTEC.spa
dc.relation.referencesICONTEC. (1997). NTC 4045 – Agregados livianos para concreto estructural. Bogota: ICONTECspa
dc.relation.referencesICONTEC. (2005). NTC 3494 – Determinacion de la retenci ´ on de ´ agua de los materiales utilizados para el curado del concreto, NTC. Bogota: ICONTEC.spa
dc.relation.referencesKovler, K. and Jensen, M.O. (Eds.). (2007) Internal Curing of Concrete - State-of-the-Art Report of RILEM Technical Committee 196-ICC. Bagneux: RILEM publications.spa
dc.relation.referencesNeville, A. M. M., and Brooks, J. J. (2010). Concrete Technology. Harlow, England, New York: Prentice Hall. DOI: 10.1016/ 0360-1323(76)90009-3spa
dc.relation.referencesShafigh, P., Jumaat, M. Z., Mahmud, H. Bin, and Hamid, N. A. A. (2012). Lightweight concrete made from crushed oil palm shell: Tensile strength and effect of initial curing on compressive strength. Construction and Building Materials, 27(1),252-258. DOI: 10.1016/ j.conbuildmat.2011.07.051spa
dc.relation.referencesSaffar, D. M. Al, Saad, A. J. K. Al, and Tayeh, B. A. (2019). Effect of internal curing on behavior of high-performance concrete: An overview. Case Studies in Construction Materials, 10(e00229). DOI: 10.1016/j.cscm.2019.e00229spa
dc.rights.accessrightsinfo:eu-repo/semantics/openAccessspa
dc.rights.creativecommonsAtribución-NoComercial-SinDerivadas 4.0 Internacional (CC BY-NC-ND 4.0)spa
dc.subject.proposalAbsorptioneng
dc.subject.proposalChloride resistanceeng
dc.subject.proposalContractioneng
dc.subject.proposalInternal curingeng
dc.subject.proposalLightweight aggregateseng
dc.subject.proposalLightweight concreteeng
dc.subject.proposalSlumeng
dc.subject.proposalSuperabsorbent polymers (SAP)eng
dc.subject.proposalAbsorciónspa
dc.subject.proposalAgregados ligerosspa
dc.subject.proposalAsentamientospa
dc.subject.proposalConcreto ligerospa
dc.subject.proposalContraccionspa
dc.subject.proposalCurado internospa
dc.subject.proposalPolımeros superabsorbentes SAPspa
dc.subject.proposalResistencia a clorurosspa
dc.type.coarhttp://purl.org/coar/resource_type/c_2df8fbb1spa
dc.type.contentTextspa
dc.type.driverinfo:eu-repo/semantics/articlespa
dc.type.redcolhttp://purl.org/redcol/resource_type/ARTspa


Ficheros en el ítem

Thumbnail

Este ítem aparece en la(s) siguiente(s) colección(ones)

Mostrar el registro sencillo del ítem

https://creativecommons.org/licenses/by-nc-nd/4.0/
Excepto si se señala otra cosa, la licencia del ítem se describe como https://creativecommons.org/licenses/by-nc-nd/4.0/